Bond Machine Knitting - Tunic Style Pullover Pattern

Date: Sun, 12 Jul 1998 14:35:37 -0700
From: bahrens@pacbell.net
Subject: [BOND] Womens XL Tunic Style Pullover-CORRECTED

Hi Guys,
I found some math problems with this pattern and thought I should 
repost it for you all....So here it is....gina

Women’s XL Tunic Style Pullover

Yarn: 9 skeins wool-ease in gray ragg

Gauge: 16st x 26 r = 4 inches

Keyplate: dot 3

Measurements: 	
L-Finished Bust-48”  XL-Finished Bust-49”  XXL-Finished bust- 50”
Sleeve Length-16”       Sleeve Length-17”          Sleeve length- 18”
Body Length-32.5”      Body length-33.5”           Body length -34.5”


Back: cast on 72, 88, 104 needles in WY....K 6 R.....Switch to MC and K
33 R.....At the carriage side of the next two rows increase 3 needles
with and e-wrap increase.....K 88, 94, 101 R......Mark this row at each
end for arm hole........K 72 R......Cast off center 26, 30, 34 stitches
onto 6 rows of WY.....Then cast off each shoulder(26, 32, 38 stitches on
each side) onto WY.......remove from machine and set aside....

Front: work as for back up to armhole markers......K 38 R.....Remove
center 20 stitches onto WY....Put LH needles into HP and working on
right side decrease 1 stitch at neck edge every row2, 3,  4
times...decrease 1 stitch every other row1, 2,  3 times.....until 26,
32, 38 stitches remain......K 23 R even... Cut yarn end leaving a 2 foot
length....K 6 R WY but do not remove from machine.......repeat for LH
side......

Back and Front Ribbing:  Rehang bottom edge of back onto 70, 86, 102
needles....Do Not remove WY.....K 18 R.....Drop and latch up every third
stitch......Back stitch BO....Repeat for Front......

Side Vents: Hang the side edge of the back from the ribbing edge to the
bottom of the 3 stitch increase onto 33 needles....Make sure wrong side
in facing you......Hang Hem and K 1 R.....Hook the first stitch of the 3
stitch increase onto the end stitch of the row you just knit........K 2
R.....Hook second stitch the same as the first.....K 2 R....hang the
last stitch...K 2 R and bring up an edge stitch to hang here.....Drop
and latch up every third stitch.....back stitch BO( include the rehung
edge stitch when you BO).....

Neckline: Place one side of back shoulders onto 26, 32, 38 needles with
right side facing out at you.....Push back against bed of
machine......Place corresponding front shoulder onto the same needles
with wrong side facing you( right sides should be together)......Use
claw weights to weight the knitting.......Thread the 2 foot length threw
the carriage push the needles back until the loops from the back come
out and over the loops of the front so you only have one loop on each
needle.....K 1 row and then back stitch BO....remove from
machine.....Place all stitches around neckline onto machine ( do not
miss any or you will have holes)....Do not rehang other shoulder at this
time......Push knitting back against carriage leaving needles in
HP.......Hang weighted hem and push it back too...... pull out allot of
MC yarn from your skein and  lay it across the open
needles..........Leave a generous length at the skein end.....Remove the
guide wire from your carriage.....Push the needles back to
FWP.......closing the MC yarn in the latches.....Push carriage across
the knitting slowly to knit 1 R........remove every third stitch to WY
and K 14 R.....Latch up stitches on WY and then cast off onto 6 R
WY....Repeat shoulder procedure for the remaining open shoulder ...Do
not rehang ribbing....This seam will be closed by hand later.......

Sleeves: Bring forward 86 needles.....Hang edge of body between armhole
markers onto these needles being sure to evenly space out extra
stitches....hang hem.....Push knitting and hem back against bed of
machine and K 1 row as for first row of neckline ribbing......K 10, 13,
15 R.......Decrease 1 stitch at each end of next row and then every
following 2, 3, 4th row 14, 16, 17 times, until 50 stitches remain.....
Knit 7, 10, 14 R even.....Cast off onto WY......

Sleeve Ribbing:  Rehang sleeve with wrong side facing you onto 45
needles......remove every third stitch and leave on WY....K 16
R......Latch up stitches on WY....Back stitch BO.....repeat for other
sleeve......

Finishing: Sew side seam at neck edge and fold over neck ribbing and sew
down.....Block sweater....Sew side seams and sew in all loose ends.....

- -- 
The Ahrens family
San Jose, CA
bahrens@pacbell.net

Back ArrowBack to the Bond List Thoughts Page Back to Steph's Home Page E-Mail
Please e-mail any comments to me at steph@stephthornton.co.uk

Author : Steph Thornton.
Last modified on : 13th July 1998.